This option will plug your vias with an additional paste. Whether this plugging will be type 3 or 4 depends on the layout files and the chosen production parameters. You can read further information about the plugging and filling types here (
Information about multi-panles and PCBs:
You can always only calculate one type of PCB. You may chose one of the different ways of delivery (see below). Different PCBs on one panel (multi-panels) can nor be calculated. Please send a enquiry for multi-panels to us and you will reply within the fastest possible time.
Explanations of the delivery types:
as single PCB
You will receive single routed PCBs. Small PCBs (both sides <20mm or total area <300mm²) will be delivered in a routing panel. This panel may contain 2mm web routings and a 6mm panel frame on all sides. In case you prefer a single PCB with a panel frame, please select "custom panel".
as Custom Panel
We design the panel according to your requirements (descriptions, drawings or Gerber files). Please fill in the total panel size in "size of panel" and the step & repeat inside the panel "step & repeat". E.g. if you fill in a step & repeat „2x5“ (10up-panel) the total quantity has to be 10, 20, 30 or another multiplier of 10.
Requirements: 2mm-routing between the PCBs is possible (the PCBs itself are allowed to contain smaller routings.), or v-cut. The PCB must contain identical PCBs. Multi-panels are not included in this option (see above).
Connector gold requires a connection of the pads via traces, called "plating bus". This bus provides the electrical connection to the pads so that we are able to plate electrolytic gold. For this reason, only pads that are lying on the outside of the PCB layout can be plated with connector gold. Usually this means “connectors”. The bus traces will later be cut in the routing process so that there is no electric relevance to them.
However, depending on the distance of the pads to the outline and the desired bevelling angle, remains of the plating bus traces may be visible next to the pads. Plating pads that are further inside the layout can only be done in exceptional cases, requires additional work and therefore must be enquired separately by email. We do recommend bevelling for any connector. The bevelling option can be found further down in the calculation.
You already calculated your quotation or received one from Leiton?
Then type in the quotation number here!
We can consult you by phone, email or in person on site.